The Controller is the board that controls the pivots when it has Irricontrol automation. To install it, follow the steps below:
Mechanical Installation
The mechanical installation of both the Nexus Panel and the SmartConnect Panel is the same. In this way, follow the step-by-step below to perform the mechanical installation.
- Snap the Controller as shown below into the correct location.
-
Fit the nuts, according to the video below, on the four ends of the Controller.
-
Using a Phillips screwdriver, screw in the four screws (one for each nut).
-
In the end, the Controller will be installed with all the nuts in the correct place.
Electrical Installation
With the mechanical installation completed, connect the terminals ("What does that mean?") according to the instructions below.
Nexus
Follow the diagram below to connect the green terminals.
The video below shows how the terminals must be connected to the Controller.
SmartConnect
Follow the diagram below to connect the green terminals.