Commands to move a pivot or to send irrigation can be done by the Controller itself. That way, in cases where the Farm doesn't have internet at the Central, it will be necessary this kind of use.
The topics below show how an irrigation programming is done in simple mode, by angle, by segment or by schedule.
Note: To enable english subtitles in the videos below, click on the icon .
Simple Irrigation
The video below shows a little more about how to configure a Simple Irrigation on a Controller G2.
Irrigation by Schedule
The video below shows a little more about how to configure an Irrigation by Schedule on a Controller G2.
Irrigation by Segments
In Irrigation by Segments, differently from Simple and by Schedule irrigations, it is necessary to configure all segments before sending a command to the pivot. The video below shows how to configure the Segments of a pivot.
When all the segments are defined, it is possible to set the Irrigation by Segments, the following video shows how to configure the command.